27

2021

-

09

Processing Requirements for Fiber Cement Board Panels


When it comes to decorating curtain walls, fiber cement boards are used extremely frequently. So, to ensure aesthetically pleasing installation and to comply with construction standards, how should we install the panels, grooves, and back-bolt holes?

When it comes to decorating curtain walls, fiber cement boards are used extremely frequently. So, to ensure aesthetically pleasing installations and to comply with construction standards, how should we install the panels, grooves, and back-bolt holes?
Panel Processing Requirements:
⑴ Cutting, grooving, and drilling of fiber cement boards should be carried out in a dry environment.
⑵ When performing machining operations, it is advisable to use dedicated machinery and equipment to ensure processing quality.
⑶ When cutting fiber cement boards, dust is generated; therefore, proper protective measures must be taken, and dust removal work should be carried out.
⑷ The edges of sheet materials that have undergone cutting or grooving must be treated with edge waterproofing (2–3 coats of a silicone-based water repellent can be applied).
Slot machining requirements:
⑴ Groove machining should be performed using the corresponding mechanical equipment, and the saw blades used for groove cutting must be kept sharp. It is not advisable to use handheld tools for on-site machining.
⑵ The width, length, and location of the grooves shall comply with the design requirements.
⑶ The sides of the groove must be free from damage or chipping, and the interior of the groove should be smooth and clean, with no visible steps.
⑷ The allowable deviation in the dimensions for grooving and machining fiber cement boards shall comply with the provisions in the following table.
Requirements for machining back anchor holes:
⑴ The back bolt holes shall be machined using the corresponding drilling equipment designed for use with the back bolts.
⑵ The back texture at the back bolt connection should be sanded smooth, and the sanded area must be even and flat.
⑶ The number, location, and depth of the back‑anchor holes shall comply with design requirements. The drilling and reaming diameters shall meet the technical specifications for back‑anchor products. For flush-type back anchors that are directly connected to the back side of the fiber cement board, the drilling depth shall be controlled to the distance from the curtain wall’s decorative surface to the bottom of the hole.
For spaced back anchors connected via connectors, the drilling depth should be controlled to the distance from the curtain wall’s decorative surface to the bottom of the hole, as well as the distance from the visible surface to the bottom surface of the connector.
⑷ Back anchors may be installed by pressing or rotating; the tightening torque of the back anchors shall comply with the manufacturer’s specifications. After installation, it must be confirmed that the connections are secure and the system operates reliably.
⑸ The back bolt holes must be free from damage or chipping, and the inside of the holes should be smooth and clean.
⑹ The allowable deviation in the dimensions for back‑anchor hole machining shall comply with the requirements specified in the following table.